PowerSupply-PLC Interface
As the current Meca500 power and safety module (PowerSupply) cannot be directly interfaced to a PLC without additional resistors, we have developed this module to simplify this operation and to be able to directly and simply connect PLC’s I/O to the PowerSupply.
Simple wiring
This accessory allows you to simplify and standardize the wiring because you only need to use a standard D-Sub 15 cable to connect the PowerSupply to the HoroBot B501, then use the screw terminal of the latter to wire the I/O directly to your PLC.
A conversion module is also integrated so that you can use a NPN ou PNP input of your PLC.
Technical data
° Dimension :
45x80x35mm (width x depth x height)
° Fixing :
DIN rail clip
° X1 Connector :
1x Sub-D 15p male connector / Connection with standard cable on the PowerSupply
Technical data
° X2 connector :
12x screw terminals (0.5mm² max) / Wire connection to your PLC
° Input voltage:
24VDC
° Output voltage :
24VDC / NPN ou PNP (for the “External power status detection” output)
Documentations
